Maxsa-innovations Battery-Powered Motion-Activated LED Outdoor Wall Manuel d'utilisateur télécharger pdf

The LED Outdoor Wall Sconce is perfect for porches, doorways,

or around the house.

The LED Outdoor Wall Sconce has a built-in motion sensor,

which automatically turns on the light when movement of a heat

source (such as people, animals, or cars) is detected in the area.

The light remains on while motion continues to be detected in

the area.

The

LED Outdoor Wall Sconce

also has a built-in photosensor so

that the light only turns on at night.

The

LED Outdoor Wall Sconce

may function irregularly or not at

all at temperatures below 0° F / -17.8° C. Normal operation will

return when the temperature rises.

The batteries typically last up to 1 year under normal operation.

The 2 super bright SMT LEDs in the

LED Outdoor Wall Sconce

have an estimated life of 30,000 hours, so they should never

need changing.

The

LED Outdoor Wall Sconce

requires 4 C cell batteries (not

included).

1. To access the battery compartment, remove the 2 thumb

screws from the top cover. Remove the top cover.

2. Remove the battery compartment cover by squeezing the two

tabs on the opposite sides of the cover inward and pulling up.

3. Install the 4 C cell batteries in the proper +/- polarity orienta-

tion as shown in the illustration above. The positive ends of the

batteries should face the low battery contacts and the negative

ends of the battteries should face the elevated spring terminals

in the battery compartment. If your unit includes a clear rubber

spacer between the two halves of the battery compartment,

please reinsert it between the two halves.

4. Reinstall the battery compartment cover by aligning the tabs

and pressing the battery compartment cover down until the

battery compartment cover clicks into place. Once the compart-

ment is closed, the light should activate to show that power is

getting to the SMT LEDs.

5. Reassemble the

LED Outdoor Wall Sconce

by replacing the top

cover and reinstalling the two thumb screws. Tighten the

thumb screws by hand as tightly as possible to ensure a

waterproof seal.

ABOUT YOUR LED OUTDOOR WALL SCONCE

BATTERY INSTALLATION

BATTERY INSTALLATION (CONTINUED)

page 1

Model #44219

ASSEMBLY AND INSTRUCTION GUIDE

Thumb Screw

Battery Compartment Cover

4 C Batteries

Squeeze tabs inward

Insert 4 C batteries

in the proper +/

orientation

1 2 3

Résumé du contenu

Page 1 - LED Outdoor Wall Sconce

The LED Outdoor Wall Sconce is perfect for porches, doorways, or around the house.The LED Outdoor Wall Sconce has a built-in motion sensor, which auto

Page 2 - 30 feet or more from street

page 2Note: If your LED Outdoor Wall Sconce does not turn on after battery installation: • Make sure the batteries have been inserted matching the c

Commentaires sur ces manuels

Pas de commentaire

Maxsa-innovations Battery-Powered Motion-Activated LED Outdoor Wall Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Maxsa-innovations Battery-Powered Motion-Activated LED Outdoor Wall . Maxsa Innovations Battery-Powered Motion-Activated LED Outdoor Wall Sconce in Golden Copper User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Maxsa-innovations Battery-Powered Motion-Activated LED Outdoor Wall